Responsibilities :

Designing and development of new hardware functional system for multiple products.
Collaborate with with the embedded software development team for hardware/ firmware co-design and system performance requirement translating to design implementation ; optimization.
Ability to synthesize user and technical performance hardware requirements and develop appropriate solutions.
Electronic component and circuit analysis to design functional sub-system by simulation and physical implementation.

Requirements & Skills :

Must to have :

2 years to 5 years of experience in low-power circuit design, system bring-up, engineering-build integration and debug.
2 years to 4+ years of experience driving design development from component selection, schematic capture, PCB layout and routing, Component foot-print for the product Electronics BoM through assembly.
3+ of experience in Multi-layer, mixed-signal board-level design in Altium/ Eagle.
Experience of power topology: DC-DC, Flyback Converters, LDOs, etc.
Experience of Battery charger design, fuel gauge, analogue sensor instrumentation; protection circuits.
Hand-on experience in hardware implementation of embedded system data communication protocols such as 1-wire, I2C, SPI, UART, USB.
Experience of BDC/BLDC or steppers motors, motor drive circuit design and its working principles.
Diverse experience in microcontroller/ microprocessor based circuit design and bring-up. Ideally from ST/ TI/ NXP/ Renesas and sensor interface on PCB assembly level.
Ability to design and implement smart sensors, sensors instrumentation like current, voltage signal conditioning, Time-of-Flight, Proximity, Position, ALS, etc on a PCB assembly level.
Knowledge about Design calculations/Documentation during Product Development Life Cycle milestones.
Knowledge of EMI- EMC and ESD standards and practices is a plus

Good to have :

Strong communication and documentation skills and ability to operate independently.
Experience with portable, battery operated designs and power budgeting.
.Knowledge about Wi-fi, Bluetooth, BLE, RF Antenna design Technologies is a plus.
Experience of Microphone and Speaker circuit design is a plus
Familiar with PCB fabrication technologies, Rigid-Flex PCBs, Flex Cables.
Hand-on experience of manufacturing process including DFM and DFT for consumer products at scale.
Familiar with MIPI Camera CSI and DSI interface implementation ; display Modules and their communication protocols; Audio signal processing interface.

Junior Electronics Hardware Engineer